Subscribe

Equipment

#10005582
  • BY: Will Ryer & Son, Inc.
  • Completely REBUILT and RESTORED in 1988 Line Puller/Tensioner Winder with brand new Anan engine.

    The puller was meticulously restored in 1988 and only has 10.5hrs of use (both engine and physical unit). The puller is in MINT working condition and every part of the unit was restored for prime optical use. Some of the features includes:

    ENGINE: New Onan Gasline Engine (10.5hrs of use as of July 2016) 20 bhp (14.9 kw) at 3900 rpm.

    REEL CAPACITY: Reels up to 108 diameter and 53 inches wide (length) are easily accommodated. The power unit slides before and after hydraulically to adjust for diameter. Shaft diameter is 2 1/2 and shaft length is 62 1/2. The drive rollers are easily adjusted for reel width by use of crank actuated screws.

    HYDRAULICS: Open center systems; 7 gpm, 2000 PSI gear pump; 10 gallon reservoir with wire mesh suction filter and oil level sight gauge; stacked valves with pressure relief.

    ELECTRICAL: All wiring in loom, conduit or frame; all connections at terminal blocks on engine, control box, rear tool boxes and trailer tongue; sealed beam lights are recessed and shock mounted; all switches and gauges heavy duty automotive and marine type.

    FRAME: Rigid type, boxed heavy structural steel, fully welded and reinforced. AXLE: 20,000 lbs stub spindle; heavy duty bearings; single wheel; heavy duty cast hubs and drums 10 hole mounting.

    BRAKE: 16 1/2 x 5 12v electrical (std) with breakaway switch and manual switch for maneuvering control.

    TIRES: 10:00 x 20, 13,500 GAWR, Load Range F.

    OTHER HIGHLIGHTS: Hydraulic Reel Lifting Cylinders, Hydraulic Actuated Idler Wheel, 2 1/2 Reek Mandrel Reel, Two 5 Bushings with Brash Inserts and Locking Collars.
  • QTY: 1
  • ZONE: CA
  • PRICE: 13,999
Contact Seller
View Storefront

Click a photo to enlarge